Correlation between metal-ceramic bond strength and coefficient of linear thermal expansion difference

Authors

  • Stella Crosara Lopes University of São Paulo; Dental School of Ribeirão Preto; Department of Dental Materials and Prosthodontics
  • Valéria Oliveira Pagnano University of São Paulo; Dental School of Ribeirão Preto; Department of Dental Materials and Prosthodontics
  • João Manuel Domingos de Almeida Rollo University of São Paulo; Engineering School of São Carlos
  • Mônica Barbosa Leal University of São Paulo; Dental School of Ribeirão Preto; Department of Dental Materials and Prosthodontics
  • Osvaldo Luiz Bezzon University of São Paulo; Dental School of Ribeirão Preto; Department of Dental Materials and Prosthodontics

DOI:

https://doi.org/10.1590/S1678-77572009000200010

Keywords:

Metal-ceramic, Bond strength, Ni-Cr alloy, Pd-Ag alloy, Dilatometric test

Abstract

The purpose of this study was to evaluate the metal-ceramic bond strength (MCBS) of 6 metal-ceramic pairs (2 Ni-Cr alloys and 1 Pd-Ag alloy with 2 dental ceramics) and correlate the MCBS values with the differences between the coefficients of linear thermal expansion (CTEs) of the metals and ceramics. Verabond (VB) Ni-Cr-Be alloy, Verabond II (VB2), Ni-Cr alloy, Pors-on 4 (P), Pd-Ag alloy, and IPS (I) and Duceram (D) ceramics were used for the MCBS test and dilatometric test. Forty-eight ceramic rings were built around metallic rods (3.0 mm in diameter and 70.0 mm in length) made from the evaluated alloys. The rods were subsequently embedded in gypsum cast in order to perform a tensile load test, which enabled calculating the CMBS. Five specimens (2.0 mm in diameter and 12.0 mm in length) of each material were made for the dilatometric test. The chromel-alumel thermocouple required for the test was welded into the metal test specimens and inserted into the ceramics. ANOVA and Tukey's test revealed significant differences (p=0.01) for the MCBS test results (MPa), with PI showing higher MCBS (67.72) than the other pairs, which did not present any significant differences. The CTE (10-6 oC-1) differences were: VBI (0.54), VBD (1.33), VB2I (-0.14), VB2D (0.63), PI (1.84) and PD (2.62). Pearson's correlation test (r=0.17) was performed to evaluate of correlation between MCBS and CTE differences. Within the limitations of this study and based on the obtained results, there was no correlation between MCBS and CTE differences for the evaluated metal-ceramic pairs.

Downloads

Download data is not yet available.

Downloads

Published

2009-04-01

Issue

Section

Original Articles

How to Cite

Correlation between metal-ceramic bond strength and coefficient of linear thermal expansion difference . (2009). Journal of Applied Oral Science, 17(2), 122-128. https://doi.org/10.1590/S1678-77572009000200010